Note: Large metallic objects, electronic devices that are used to purchase gasoline or similar items, or a second coded key on the same key chain may cause vehicle starting issues. Never remove the coolant reservoir cap while the engine is running or hot. It will return at approximately 25 miles 40 km , 10 miles 16 km and 0 miles 0 km to empty. Make sure the headlamps are off. It is important to follow the proper wheel mounting and lug nut torque procedures.
Replace the spare tire with the road tire as soon as possible. Refer to Wired Headphones following. If this is not possible, wait a short period for the engine to cool. Apply the accelerator slowly and steadily when starting from a full stop. Clip the tether strap to the anchor as shown. The lid cannot be opened in the upright position.
Remove the bulb socket from the foglamp by turning counterclockwise. Note: In the illustrations, lightning bolts are used to designate the assisting boosting battery. Children 12 years old and under should be properly restrained in the rear seat whenever possible. Remove the jumper cable from the ground metal surface. Set the parking brake, press and hold the clutch pedal, place the gearshift in N Neutral , and release the clutch pedal.
Ford Motor Company shall not be responsible for any such programming changes. Refer to the Driving chapter for transmission function and operation. Some user manual might contains a serial number of the respective product that almost perhaps not identical with your own. If starting a vehicle with an automatic transmission: 1. Rotate the bulb socket counterclockwise and remove from lamp assembly. To reset the trip, press and hold the stem until it resets.
If the fuel filler cap is venting vapor or if you hear a hissing sound, wait until it stops before completely removing the fuel filler cap. Try to pull the belt out of the retractor to make sure the retractor is in the automatic locking mode you should not be able to pull more belt out. As with other vehicles of this type, failure to operate this vehicle correctly may result in loss of vehicle control, vehicle rollover, personal injury or death. If equipped, use the tachometer and do not allow engine speed to exceed the redline area. Ford may change the contents without notice and without incurring obligation.
If the light flashes steadily, have the system serviced immediately, damage to the transmission could occur. This applies to Ford-completed vehicles of 10,000 lb. Rear axle lubricant quantities are not to be checked or changed unless a leak is suspected or repair required. Insert the hooked end of the jack handle into the jack and use the handle to slide the jack under the vehicle. Lift the hood until the lift cylinders hold it open.
If the engine oil level is not within the normal range, add only certified engine oil of the recommended viscosity. Do not touch them after inflation. Pull out the old bulb from the socket and push in the new bulb. Use of these systems may result in vehicle starting problems and a loss of security protection. Set the temperature to 60°F 16°C. Turn all other accessories off. When working near the battery, always shield your face and protect your eyes.
Install the bulb s in reverse order. Depending upon the type and placement of the load, hauling cargo and people may raise the center of gravity of the vehicle. The heated seats turn off when the ignition is turned off. Make sure the headlamps and electrical accessories are off. Once you have found your information, just print it out and start work. To increase airflow to the outer instrument panel vents, close the vents located in the middle of the instrument panel. Refer to the Scheduled Maintenance Guide for the service interval schedules.